Also, be sure to check the manual of the projector or consult the manufacturer to ensure that you are handling the projector in the correct way.Ī blinking green light on a Mitsubishi WD-65833 television can indicate that the television is in standby mode, and is trying to establish a connection with a signal source (such as a cable or satellite box). It's best to be sure that the projector is unplugged and you have a static free environment. Please be cautious when handling the projector. Power on the projector and test the audio to see if the wire has been reconnected properly.Check to make sure that the wire is not in contact with any other components on the circuit board, as this could cause a short circuit.Carefully reconnect the wire to the connector, making sure that the wire is securely connected and properly aligned.This should be easy to spot as it will likely be the only empty connector in the area. Identify the connector on the circuit board where the wire originally came from.Here are some steps you can take to reconnect the wire: It's important to reconnect this wire properly in order to restore audio functionality to the projector. It sounds like the wire you're describing is likely a connection wire for the audio component of your Mitsubishi 73838 projector. You may not need to do anything to or with your machine's power supply at all but it doesn't hurt to check anyway so that you can rule it out as a possible problem source. I replaced every electrolytic in the PSU - and after plugging the module back in and turning the VCR on, the playback picture and tape counter were soon restored to normal - after some soak-testing, the machine went home. With another Panasonic (NV-J11A), it was several out of tolerance electrolytic capacitors in the power supply (another metal-cased plug-in module) that caused the snow on screen, erratic tape counter, and slightly wobbly audio. Power supply was OK and the whole VCR good to go. Here are a couple of examples of similar VCR issues I've had some years ago, I had a Panasonic NV-F70A, with snowy video playback, and, after a lot of investigation and exhaustive testing it turned out to be the video head amplifier module that was the problem (not the heads themselves which were new) - replacing the plug-in aluminium-cased module fixed it and restored the video picture as well as the stereo audio output and flying head erase. You could also check the power supply to see if any electrolytic caps are out of tolerance or have changed value and replace them if necessary. Head amplifier circuit/module could be the problem in your case.

Mitsubishi hs u540 manually